sifz6
New Member
Only my second post here but I've been reading A LOT on the naked conversion.
I'm going for an OEM conversion and have purchased pretty much all the parts to do this (down to the radiator hose). The only thing that's putting me off is soldering the wires etc. I'm ok at soldering, I'm just terrified of ruining the wiring!
My question is, if I can get hold of a wiring harness from a FZ6N - would it be better to just swap them out? Assuming they're the same. Is that actually a feasible option without completely stripping the bike? Or maybe I could chop the old harness and marry up the headlight/front end section to it?
Any ideas (or moral support) would be greatly appreciated.
I'm going for an OEM conversion and have purchased pretty much all the parts to do this (down to the radiator hose). The only thing that's putting me off is soldering the wires etc. I'm ok at soldering, I'm just terrified of ruining the wiring!
My question is, if I can get hold of a wiring harness from a FZ6N - would it be better to just swap them out? Assuming they're the same. Is that actually a feasible option without completely stripping the bike? Or maybe I could chop the old harness and marry up the headlight/front end section to it?
Any ideas (or moral support) would be greatly appreciated.
Last edited: