Speedometer Bracket Group Interest.

[Lagerhead]

Count me in

 

[LeaN69]

based off of the sketch provided heres the model pictures attached, and it being overlayed with S2 mount for comparison.

-Russ

 

[fazil]

It should stay in this direction (opposite)

 

[chunkygoat]

Purchased, thank you! I'm stoked to throw this bad boy on there this winter! There's a good chance I'm going to have signals and front fairing up for sale come january!

 

[LeaN69]

fazil: is the mounting point on the opposite side? should the flange be centered or like you displayed it (on the left side) ?

From my understanding the sketch, was from the back of the mount, correct?

 

[LeaN69]

Like this?

 

[fazil]

fazil: is the mounting point on the opposite side? should the flange be centered or like you displayed it (on the left side) ?

From my understanding the sketch, was from the back of the mount, correct?

Yes exactly. Like in the last picture you have sent.

The sketch is from an OEM yamaha FZ6 N bracket.
I'll post a picture of the bracket soon.

 

[LeaN69]

Yes exactly. Like in the last picture you have sent.

The sketch is from an OEM yamaha FZ6 N bracket.
I'll post a picture of the bracket soon.

Sound great, thank you, only "typo" I think is that sketch states Radius for holes while I'm sure the valuas are Diameters. When I put them in as R. they seemed way too large.

 

[fazil]

Yes they are diameters.
Here are some pictures.
Attention to first picture.
According to your model, fitment can be a problem because of the wiring.
I am not sure.

I am planning to go naked soon,
that's why i am researching for the fitments.

 

[LeaN69]

hmm, looks like the harness plugs into the bottom on the S1's as opposed to the S2 which is towards the top of the mounting holes.

If somebody could take measurements of required clearance in relation to holes that would be very helpful.

 

[fazil]

Lean,

I'll drawed it in autocad.
Please write me your email adress if you want it.

Fazil

 

[LeaN69]

pm'd with the email.

 

[Lagerhead]

What kind of metal is going to be used, and what is the thickness?

 

[Kenward]

Hey LeaN69, sent my payment early last month, still waiting on a shipment. Sent you a PM too. Thanks!

 

[LeaN69]

Hey LeaN69, sent my payment early last month, still waiting on a shipment. Sent you a PM too. Thanks!

Pm replied was shipped out over week ago.

 

[LeaN69]

What kind of metal is going to be used, and what is the thickness?

I've used 16ga CRS for the current S2 mount, s1 will more then likely be same.

 

[visions]

Any news on this?

Thanks :thumbup:

 

[LeaN69]

Have been super busy at work, sorry guys but didn't have much time to look into s1 prototype, I will pirsue it as soon as I get a chance. I have the dimensions next step would be to build a prototype and test it out.

 

[LeaN69]

I need a person willing to try out the S1 prototype, take pictures of fitment and give feedback. Please PM me if you are interested and able to do this.

*** Must have 1st generation FZ-6 with round speedometer. Be mechanically inclined to perform all fitment steps on his own. USA residents only please.

-Russ

 

[Motogiro]

If your in San Diego I will help out on the mounting and report back to Russ. S1 is 06 and older.
I can provide CAD. for any feed back or changes.