ant_mb
Super *********
It was so much easier than I thought it would be. 1 1/2 hours start to finish, and yes I used solder.:thumbup:
-
Welcome to the Yamaha FZ6 Forums. Member registration disables ads and allows you to post and share. Register Here.
Spot the mod!!
- Thread starter ant_mb
- Start date
S
sportrider
I'm going to be bold and say Dual headlight mod?:needpics:
EDIT: I like them, kinda reminds me of my bike now (hint hint)
EDIT: I like them, kinda reminds me of my bike now (hint hint)
Looks like dual headlights and pod lights, too. Looks good :thumbup:
ant_mb
Super *********
Fred
M em b er e d
Found em!
S
sportrider
the resemblance is uncanny, great color too!!!
someone08
Junior Member
where did you get the pod lights and how much? i would love to do this but i havent found very many.
ant_mb
Super *********
I ordered them from my dealer, and they ran me a little over $21. The Yamaha part number is 5PW-84312-00. I picked up a couple 194 bulbs from pep boys for $4 and I was done. $25 and an hour and a half aint too shabby.
It takes me about an hour to mow my lawn.
But how did you use solder to do it?
But how did you use solder to do it?
Thanks for the part number, I think this will be my mod project for this weekend........ after I mow my lawn down a bit. I hope my local Yammy dealer has 'em in stock.
Looks good...:thumbup:
Did you use a Glass 194 bulb or LED?
Did you use a Glass 194 bulb or LED?
nice looking pods, did you do a "how to"? I might have to check these out up close and personal this weekend.
ant_mb
Super *********
I used the standard glass bulbs from Pep Boys.
I normally would have, but I wasn't sure how long it would take so I ran right through it. I can explain it too you this weekend, it's pretty simple.
I want to know too! 
I want to see how you modded the pods and how these stay in! Great job!!
I want to see how you modded the pods and how these stay in! Great job!!
chemicalsmile
Junior Member
For anyone looking to do this mod, I found these on eBay. I just bought 2 and the grand total with shipping was around 9 bucks.
ant_mb
Super *********
Are you sure that will fit? The pod housing is a certain size, and the R1 harness fits it like a glove. Let us know how it turns out.
chemicalsmile
Junior Member
Well they look about the same size and I figured I'm custom drilling the hole anyways so I'll make it fit. :rockon:
ant_mb
Super *********
It will work as long as it's not too big. Picture a straw with one end blocked off. This is the end your drilling into to make the straw open so you can insert the harness, you drill too much and you break the outer walls. It's kinda hard to explain.
I used the same type of unit. Just drilled the hole slightly smaller and the rubber socket just squeezed in there beautifully. Havent had any issues yet
Similar threads
