ltdillard
commutaholic
Greetings.
2007 FZ6, stock front end.
I tore down my front forks to replace the seals and and noticed that the large washer (#12 in Service manual diagram on page 4-65; or "upper cover guide" part number 4TX-23115-00-00) of one side is different than the other. I'm pretty sure they ought to be the same.
One side is perfectly flat as expected, and the other one is as if you took the outer edge and pulled up on it all the way around. It almost looks like it was made that way, though as I said I think it should be flat.
Has anyone else come across this before?
I'm ordering new ones just to be safe.
Tom
2007 FZ6, stock front end.
I tore down my front forks to replace the seals and and noticed that the large washer (#12 in Service manual diagram on page 4-65; or "upper cover guide" part number 4TX-23115-00-00) of one side is different than the other. I'm pretty sure they ought to be the same.
One side is perfectly flat as expected, and the other one is as if you took the outer edge and pulled up on it all the way around. It almost looks like it was made that way, though as I said I think it should be flat.
Has anyone else come across this before?
I'm ordering new ones just to be safe.
Tom