My Fender Eliminator

[Daybreaker]

Built my own Fender Eliminator from scrap material I had laying around. I wanted to use my stock turn signals and tuck them in close. Making that egg shaped hole for the stock lights was a little time comsuming, built I think it payed off. Check it out and let me know what you think.
Later...

 

[CombatPenguin]

Looks good and very sturdy with the welds. I agree those holes for the lights are very time consuming.

 

[FZ1inNH]

Looks solid! Well done. :thumbup:

 

[Shinn]

Looks amazing, especially considering that was all scrap. :thumbup:

 

[Daybreaker]

Looks amazing, especially considering that was all scrap. :thumbup:

The scrap is left over boiler plate. It will never rust.
This was a project I wanted to do but could never part with the money to buy one. There was a guy here on the Forum that had some drawings of the FE he built. I never saw it. I just had to get motovated to build my own. After amout tearing off the rear turn signals with my hip I decide that was enough. Time to get started building my own.

 

[CrazyBiker]

Good Job! But you could decrease its angle a little bit so that license plate light flows with the tail.

 

[staticghost]

Nice. I like it a lot. You saved bunch of money by making your own. Way to go.

 

[psnbye]

Not too shabby! It looks real sturdy, I have been looking at that big mass of crap under my fender for a while and I think I could come up with something similar... you dont have that thing patented, do you? Boilerplate? That's old school stuff!

 

[dean2287]

Good job! Nice weld beads.

 

[Luiz]

Want to make me one. I'm in Central Florida. I will pick it up, how much $$$ :thumbup: