darth47
Junior Member
Greetings,
My cycle has been having a problem I believe to be electrical. When I turn the key in the ignition to the on position, only the neutral light comes on, the fuel pump doesn't prime or make the usual 3-4 sec whirring noise. When I try to start it, the engine cranks but doesn't start. When I turn the key to the off position, the dash display comes on for a sec and goes off. I have charged the battery, the voltage after troubleshooting was 13.5V, I have checked the voltage going to the fuel pump, 0.2v, (key in on position, engine not running) but i don't know if there should be power there if the engine isn't running. I have removed and sprayed contact cleaner on almost all connectors, no joy. I even removed the ECU connector and sprayed both ends with contact cleaner, no joy. I dunno what else to try. I don't know if any one has had this experience and what they did to resolve it.
Any suggestions?
Key in on position.
Key in off position
Update:
After cleaning more connectors and checking fuses, cycle behaves normally, started and dies 2x then starts and runs normally. Yet to take it for a test ride due to bad weather.
My cycle has been having a problem I believe to be electrical. When I turn the key in the ignition to the on position, only the neutral light comes on, the fuel pump doesn't prime or make the usual 3-4 sec whirring noise. When I try to start it, the engine cranks but doesn't start. When I turn the key to the off position, the dash display comes on for a sec and goes off. I have charged the battery, the voltage after troubleshooting was 13.5V, I have checked the voltage going to the fuel pump, 0.2v, (key in on position, engine not running) but i don't know if there should be power there if the engine isn't running. I have removed and sprayed contact cleaner on almost all connectors, no joy. I even removed the ECU connector and sprayed both ends with contact cleaner, no joy. I dunno what else to try. I don't know if any one has had this experience and what they did to resolve it.
Any suggestions?
Key in on position.
Key in off position
Update:
After cleaning more connectors and checking fuses, cycle behaves normally, started and dies 2x then starts and runs normally. Yet to take it for a test ride due to bad weather.
Last edited: