• Welcome to the Yamaha FZ6 Forums. Member registration disables ads and allows you to post and share. Register Here.

Valentine 1 and Mix-It installation.

Fred

M em b er e d
Joined
Nov 6, 2007
Messages
1,787
Reaction score
65
Points
0
Location
Austin, TX
www.robietech.com
I'm very happy. With the exception of the GIVI bags and Motech rack, due to arrive this Thursday, my Fizzer is finished!

I spent the last few days wiring in my Valentine 1 radar detector. The detector itself sits on the master cylinder where it can get a good view. But the screen is impossible to see there, and of course I cannot hear the detector.

The solution? My sadly neglected remote audio and remote display units, which finally will see use.

The remote audio is hidden away behind the inner fairing panels. It's just a box that gives a headphone jack and a second volume control.

The remote display has to be seen, so I girded up my loins and started cutting my dashboard.

watermark.php


I think it worked OK.

But of course, it's not enough to have a display. Unless you plan on looking at it every three seconds, you need audio. I have custom molded earplugs with audio transducers in them, so all I needed was to plug into the headphone jack on the V1's remote audio box. Right?

But how am I going to listen to my MP3's then? And when I get a talking GPS, how will I hear that?

That's what the Mix-It does. A friend of mine designed and makes these. They will take four audio inputs and mix them together into a single output with a unified volume control. And the whole rig can clip to your belt or tankbag.

But I wanted a clean install, so I voided the warranty. A little desoldering and I had extracted the volume control, the power LED and the output jack.

I soldered them onto a daughterboard.

watermark.php


And then I cut up another fairing panel and got a tube of E6000 to glue the board in place.

watermark.php


Lastly I made a bracket to support the body of the Mix-It and put it all back together. And done!

watermark.php


My phone is also my MP3 player, so it'll be plugged into the Mix-it. I won't be able to take calls, but I'll know when I'm being called and can listen to voice messages while riding. I can also use the phone's GPS to navigate should I get lost. So the phone will be super velcro'd in place on the left fairing inner panel where I can fold out the screen and see it easily.

So let's recap what I've got.
Nautilus air horn. Fuse block and lockdown blocks for wiring. V1 remote display, remote audio, and Mix-It. Ladies and gentlemen, I am pleased to announce that my fairing is FULL!

Fred
 
Looks great! I can attest that Fred's work is first rate best of all it look OEM not aftermarket. I still want to hear those air horns.
 
I like the way you put it all together. I've got a Valentine-1 and the remote display and I was thinking about buying another display just so I could use it on the bike. Thanks for the ideas and the test fit. Howd you wire up the valentine and remote display?
 
Do you have the hardwiring kit from Valentine? It's a little bitty box with two phone jacks and an inline fuseholder. It'll fit just about anywhere on the bike. Mine's up in the right hand "ear" of the fairing. Then I just made some phone cords the right length and plugged it all in. Pretty simple really, the brackets were the hard bit.

To hold the remote display in place, there's a piece of aluminum bent into a V shape with velcro on it. It sticks to the top of the display and to the inside of the dashboard.

The display is pretty easy to fit. You can take yours and hold it up behind the dashboard and you can feel just how much room there is. I'd suggest mounting it at a slight upwards angle too, it'll make it more readable.
 
Back
Top