Kriswithak
Senior Member
After getting an awesome deal on Wolfman's second hand PCIII (THANKS!!!!) I got it installed this morning, and managed to take the bike out for a ride!
Much nicer on and off the throttle even with a map not tailored for my bike currently installed, and it cleaned up the down low which was pretty mushy since I put on the exhaust!
Have to say after initially opening the seat and tank to take a look at installing it I was feeling a bit dubious if I would be up to it, but it was actually really simple!
The only issue I had was there is this retarded formed area on the plastic under the seat its meant to velcro too, right where I wanted to put it... Anyone find a way to get around this?
Definately going to get it dyno'd after the next service!
Thanks again to Wolfman for being such a champ!
(I'll try to add some pictures later once I get the camera charged)
Much nicer on and off the throttle even with a map not tailored for my bike currently installed, and it cleaned up the down low which was pretty mushy since I put on the exhaust!
Have to say after initially opening the seat and tank to take a look at installing it I was feeling a bit dubious if I would be up to it, but it was actually really simple!
The only issue I had was there is this retarded formed area on the plastic under the seat its meant to velcro too, right where I wanted to put it... Anyone find a way to get around this?
Definately going to get it dyno'd after the next service!
Thanks again to Wolfman for being such a champ!
(I'll try to add some pictures later once I get the camera charged)