LED License Plate Light.

[Chaosratt]

Replaced the License Plate light wit one of these from Ozznium:
Tiny LED Modules : High brightness surface LEDs

used the round black one.
Simple install, the module comes with a wire length about 2 inches too short to reach the connectors, so I whacked about 3 inches off the stock light's cable at the connector side and soldered in a slice. Connected up and she's good to go!

Pro Tip: I washed out the light housing with dish soap and then wiped it down with pure isopropyl to get rid of any grit. The included 3M tape sticks fantastically well. Doubt I could get the light out again without damaging the light or the housing.

Before:


After:


Various of the light itself:

 

[Goop]

Looks good...I'm considering an LED for mine. The incandescent keeps burning out.

 

[04efi]

I had same problem with my bulb. So I put LED's on my plate. The ones from ebay that hold the plate. Nice and clean as well.

 

[cyprusgrump]

The R & G Tail Tidy comes with a neat LED light...

 

[SANGER_A2]

The R & G Tail Tidy comes with a neat LED light...

Yeah it's cool. Mine doesn't look as bright as the one the OP has, but the fender eliminator is really nice.

 

[Chaosratt]

The nice thing about the way I did it is that it'll also work with the stock setup, and most any fender eliminator that uses the stock license plate light holder. Cost was $9 + S&H (I got several more lights to do under-body lighting in these cold days ahead).