jwhelan
Junior Member
Just finished installing my fz1 bars. Was pretty painless and only made 1 DOH!
I had to loosen the bolt going to the master cylinder so I could adjust the brake lever.
After I had everything positioned to my liking, I sat on the bike and pulled in the clutch to make sure it felt right, then pulled in the brake. DOH! I forgot to tighten the bolt to the master cylinder! Brake fluid all over the inside of the fairing :ban::spank::squid:
The bolt in question is #17 on the attached pic.
The moral of the story is to always tighten bolt #17!
I had to loosen the bolt going to the master cylinder so I could adjust the brake lever.
After I had everything positioned to my liking, I sat on the bike and pulled in the clutch to make sure it felt right, then pulled in the brake. DOH! I forgot to tighten the bolt to the master cylinder! Brake fluid all over the inside of the fairing :ban::spank::squid:
The bolt in question is #17 on the attached pic.
The moral of the story is to always tighten bolt #17!