Drilled baffles, before and after

[CdnMedic]

Took the plunge, drilled them out and... well... kind of dissapointing, I didn't get much of a change, it's slightly louder, but thats it... sounds like I'll be getting a real set... So, heres the vid of before and after.

[nomedia]http://www.youtube.com/watch?v=U8p5r2Z_DTk&feature=channel_page[/nomedia]

 

[FZ1inNH]

Sounds deeper at idle but not a lot of difference at the high revs? If I am hearing that correctly anyway... I'll bet some bigger nozzles on the end of that can would make a difference! Thanx!

 

[CdnMedic]

yeah, a bit deeper tone, nothing too much louder, wich is what I really wanted to have happen with this... but it does sound better than before.
I might take the exhaust to work and have one of the techs plasma cut it open for me, gut it and weld it back together.

 

[sjryser]

where did you drill... from the tailpipes inward?

 

[alman]

I think this is the procedure
YouTube - COMO TALADRAR ESCAPES FZ6

 

[reiobard]

it does sound a bit deeper, but not much change, i think you will be pleased with the full gutting of the exhaust.

 

[Anarchy]

What kind of drill bit did you use? I was using a irvin 1/2" I think that's the brand. I burned the bit up before I got a 1/4" hole.

 

[CdnMedic]

I beleive it was a 5/8" bit, was a masonry bit that I used... I should have used a 3/4" bit...
I now have carbon two bros on it and there is no comparison, these pipes are wicked!