meadeam
Site Supporter
The stock bar has some mounting holes for the switch gear. I did not know this was the case, and neglected to do much research before taking the old bar off.
My plan is to use a punch to mark the location, and drill the holes. I don't have a drill press so I will have to do it by hand with the bar clamped down under wood blocks. Does anyone see a problem with that? Seems pretty straightforward but I always get a little nervous hacking or drilling important things like handlebars.
There are also indentations near each end of the bar. What are those for? They don't seem to have a purpose, but they are a matched pair so I feel like they need to be there for something.
My plan is to use a punch to mark the location, and drill the holes. I don't have a drill press so I will have to do it by hand with the bar clamped down under wood blocks. Does anyone see a problem with that? Seems pretty straightforward but I always get a little nervous hacking or drilling important things like handlebars.
There are also indentations near each end of the bar. What are those for? They don't seem to have a purpose, but they are a matched pair so I feel like they need to be there for something.