Diag mode not working correctly

[jamesf]

My fz6 has not had the tps recall completed. I wanted to see if my tps was out of range on diag mode, but when I went to check it I encountered an issue. I can get into diag mode fine (diag pops up on the screen), but when I press select to scroll, nothing happens. So I'm stuck on the screen that just says diag, nothing useful there. Anyone have any idea what this might be? Can't find anything when searching about this.

Edit: I'm a moron, apparently you have to hold the select and reset buttons again for two seconds after getting into diag. Please ignore this thread.