voltage

Hello guys, I read a few threads on this subject but I wasn't able to find the exact part number. I would like to replace the OEM rectifier/regulator with a MOSFET one. I read that the second one is more precise and better protects the battery and the stator. Is this true ? The original...

So I've searched the forum probably 40 times and found some good troubleshooting but have not been successful yet and all of the posts varied some from my situation. I am new to streetbikes and have just bought a used 2004 FZ6 with 22k miles. The bike cranked great for 3 or 4 days with no issues...

Hello, I checked battery voltage using diagnostic mod from cluster. (d-09 shows battery voltage) It shows 11.4V while fuel pump motor is active. (.You have to turn on kill switch to see battery voltage, and it automatically switches fuel pump motor) Batter is a 4-5 year old Yuasa. It...

So i am working on my project (remember my questions about brake light modulation?) and I have been stuck at a certain point. When I test on the bench with a stable power supply, and when I test on the motorcycle with the key on / engine off, it works fine, Start the bike and lots of odd...

Hope you guys can help Believe I've got some phantom leaky voltage somewhere as a couple things seem a bit odd to me 1 is my indicators, the dash ones. When indicating the indicators work normally but most of the time when indicating between flashes my dash indicators are dimly lit? This...

I've got a Givi top case from my previous bike that I want to mount on my new-to-me FZ6. I've got the mounting rack and plate in hand (not installed yet), but recall that the light kit on the case wasn't working when I took it off the old bike. In order to test the bulbs, I'm wondering how...

Hello guys, I searched the different threads on this subject but i was't able to find a solution for my problem. I am new to motorcycling so I am not yet familiar with its electrical/mechanical problems but I want to learn as much as possible ( preferably without having them :)) ) The problem...

I have had two licence plate bulbs burn out and I left the burnt one in for the longest time. I got a 6 smd led bulb to replace with. Before I did I checked the voltage output through the light bulb bracket. It is showing roughly around 12.9v output. Is that too high voltage? The bulbs are...

Hello all, I have my bike right outside my lounge window (no garage) so today i made an extension for my Oximiser 900. (so that the charger can stay inside but still be hooked up to the bike to keep the battery in good condition) It worked perfectly to start with but after coming back to...

My fz6 is charging (while at 5000 rpms) at 16.5V. I replaced the rectifier and it give me the same problem. It continues to charge at 16.5. The Ac Voltage output from the stator is at 13-14 vAC. Any suggestions? Checked the Diodes in the R/R The oem has a .510 and all three and the...

So I posted to this forum a little while ago with the issue of the bike sputtering between 1k and 2k; I replaced the spark plugs and charged the battery while I was at it; after that everything seemed to be A-OK. But the yesterday I was having a spirited ride in the back roads and popped a...

I've noticed my headlight doesn't work - no low/high beam, running light works though. With ignition ON, I've checked the 3 pin connector coming to the bulb and there's no voltage in there. The manual states to check the wiring from bulb to dimmer switch, the dimmer switch itself and headlight...