• Welcome to the Yamaha FZ6 Forums. Member registration disables ads and allows you to post and share. Register Here.

Replacing the crankcase cover...question

Goop

Chips & Dip
Elite Member
Joined
Sep 14, 2008
Messages
1,963
Reaction score
59
Points
48
Location
San Diego, CA
Visit site
Hey all:

I had a "mishap" a few weekends ago and dropped the bike while in a curve. My frame sliders prevented a lot of damage. Besides some scratches, minor damage to the fairing and a bruised ego and sore knee the only other damage was to the crankcase cover (on the gear shift side, mounted inside this cover is the stator.)

I ordered a new cover and gasket and they have arrived. My question is, do I need to drain the oil out in its entirety before removing this cover (I know there will be some residual oil in that area)? Or if the bike is left to sit for a few hours, will the oil settle to the bottom of the engine allowing me to avoid a full draining?

Thanks!
 
I just had the altenator cover replaced and did not have to drain the oil because it does drain into the drain pan.
 
You'll get a few drips because the flywheel is under that cover, but the oil level is below the bottom of it. I've got a brand spanking new one sitting on my desk that I'm too lazy to install.
 
Thanks for the tips...I installed the cover this weekend. While the damage to the original wasn't bad and I could've got away with just painting it, I went ahead and got a new cover. :thumbup:
 
Last edited:
BryanDH, where did you get your cover and for how much?

SHS Powersports

Honda Yamaha Suzuki Kawasaki Sea-Doo Can-Am Ski-Doo Motorcycle Parts ATV parts Scooter Parts personal watercraft parts Accessories

They have some of the best prices on OEM parts. You'll want the gasket as well. Mine was for an '08 but it's the same parts for the '06 according to the parts finder.

COVER, CRANKCASE 1
1B3-15411-10-00
$56.96

GASKET, CRANKCASE CO
5VX-15451-01-00
$4.91

Sorry to hear about your bike (I read the "FML... layed the bike down" thread). I laid mine down 3 weeks ago so I'm in the the same club!

Bryan
 
Hi Goop,
I just received the cover and the gasket, anything else I need?

Did you have drain the oil? I think there are 3 bolts for the Startor Coil Assembly inside. Did you have to do anything special?

Regards
 
Back
Top