Probably been answered but have a turn signal question

[ninjarob]

Did some searching but couldn't seem to find it I'm hooking up some flush mounts on the front and I know the power drl and ground but my question is: if my flush mounts that I bought came with 2 wires is there a way to get it to work? When I put the blue to the power it makes my back ones come on as well and it won't actually blink now when I do it spereately like just brown or just blue it works like it should but don't really know how to get it to work properly any help would be greatly appreciated thank you!!

 

[TownsendsFJR1300]

With the new light fixture, you won't have running lights up front, JUST DIRECTIONALS.

That's the two wires, ground and directional ONLY..

Black is ground.

Just find which wire is the directional wire (from the bike) and tie that in.

BTW, if its an LED light, you'll likely need a different directional relay.

And welcome to the forum!:welcome:

 

[Motogiro]

Here's a link to a wire color code for your signals. As Scott said you'll not be using your running light with the new LEDs but instaed just the directional signal. This means tape off the blue or blue with red tracer wires.

Here's the link! http://www.600riders.com/forum/showpost.php?p=586206&postcount=2

 

[ninjarob]

Hey thanks for the welcomes and the help I wasn't sure if there was a way to do it because while I like the running lights I didn't care if I had them if I could hook them up. Thanks again!!:rockon: