seb101
Junior Member
Hey
Yesterday when I was checking the chain slack and doings regular checks of things I've noticed little loseness when holding the rear wheel at 3 and 9 and moving it right/left. It doesn't happen when i rotate it to 12 and 6 and do the same or top/bottom. I didn't have time to take the wheel off to check if it's losseness on swingarm or on the wheel bearings.
Anyone had similar problems? and what is causing it swingarm bearing or wheel bearings?
Bike is from 2007 and has 28 000 km (~17400 miles) and swingarm pivot bolt, to my knowledge hasn't been serviced/lubricated yet.
Yesterday when I was checking the chain slack and doings regular checks of things I've noticed little loseness when holding the rear wheel at 3 and 9 and moving it right/left. It doesn't happen when i rotate it to 12 and 6 and do the same or top/bottom. I didn't have time to take the wheel off to check if it's losseness on swingarm or on the wheel bearings.
Anyone had similar problems? and what is causing it swingarm bearing or wheel bearings?
Bike is from 2007 and has 28 000 km (~17400 miles) and swingarm pivot bolt, to my knowledge hasn't been serviced/lubricated yet.
Last edited: