Johnson
New Member
Yes, ^^^
Also, for the adjuster to be about half ways out, it's about 3 full turns. At that setting, it IS TAUGHT when removing the outer cable from the lever.
What I do is turn the adjuster all the way in, pull IN the clutch lever, then release pulling the outside sheath. It'll clear much easier..
To re-install, basically the same BUT put the out side sheath up against the round part of the adjuster and pull the clutch lever.
That'll give you a little more cable to easily slip back into the perch..
Lastly, a little bit of grease inside the lever, where the cable barrel goes helps the plastic barrel from wearing / tearing.
How often do you lube your clutch cable and any other cables I should be lubing?