Taylor,
Check out post #43. He has a wiring diagram.![]()
Yeah I printed it but I'm not sure what type of connected to use I'd rather not use a splice connecter and I don't have a soldering tool
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Taylor,
Check out post #43. He has a wiring diagram.![]()
Yeah I printed it but I'm not sure what type of connected to use I'd rather not use a splice connecter and I don't have a soldering tool, was wondering what type of connector is best or if I should solder it thanks again
I would definitely take you up on that since I've only soldered about 3 times but my whole rear end is taken off lol I think I'm going to put the signals on but with no break lights, maybe you can show me a thing or two about electrical one of these weekends coming up. Just let me know when's good for you. (I feel wrong going to some else's house with out my tools)
Just curious how did you connect the turn signals I to the brake harness or what do you recommend for a t or y connector thanks![]()
What about the 3 cables you joined into the brake light? I had to use 6 pin connectors from RadioShack to dibble the side of the stocks taillight harness
Mm sounds good I can visualize it.
I didn't use any kind of a connector. I just exposed some of the wire and soldered it all together and heat shrink wrapped it. It's a bit ugly and I will probably clean it up next time I have it apart. Especially with the diodes in there it's a big ball of wires and could be much cleaner than I did.
I also want to shorten up some of the wires, it just barely fits under the side panel.
Since I replaced the relay with one for LEDs I wonder if I can remove the giant resistor that came with the tail light. I'm not sure if it serves any other purposes.