Recont
New Member
Hi,
After last ride noticed lumpy and high idle on my FZ6 and decided to check all the vacuum hoses for leaks. Found 1-st cylinder throttle balancer hose hanging split, which was repaired with ease and then noticed throttle to inlet joints badly cracked-all 4. After removal there were no through cracks and I was a bit disappointed with that, however decided to replace all 4. I was so surprised when I found out price of Genuine parts-£50 per joint, which I am not ready to pay.
Does anyone know if R6 joints will fit FZ6 engine as they can be purchased for £70 for all 4. Also a drawing with dimensions of joint from R6 can help.
Regards
After last ride noticed lumpy and high idle on my FZ6 and decided to check all the vacuum hoses for leaks. Found 1-st cylinder throttle balancer hose hanging split, which was repaired with ease and then noticed throttle to inlet joints badly cracked-all 4. After removal there were no through cracks and I was a bit disappointed with that, however decided to replace all 4. I was so surprised when I found out price of Genuine parts-£50 per joint, which I am not ready to pay.
Does anyone know if R6 joints will fit FZ6 engine as they can be purchased for £70 for all 4. Also a drawing with dimensions of joint from R6 can help.
Regards