Fault code 14

[kyleG]

Hi (again)

I posted at the beginning of the week about my FZ6 I worked out that it wont run because there is a problem with the air intake. fault code 14.
Is there anything i can do to fix the air intake.

Thanks

 

[Motogiro]

Not dead sure but there is a small module that reads the intake vacuum pressure. It should have a plug and a vacuum line.
Another member had a problem with this. Here:http://www.600riders.com/forum/fz6-technical/45265-fault-code-14-a.html

Fault Code: 14
Diagnostic Code: 03
Symptom: Faulty intake air pressure sensor pipe system
Probable cause of malfunction:

defective hose
clogged hose
Intake air pressure sensor hose is detached, clogged,
kinked, or pinched.
Malfunction in ECU.

You'll need to pull your air box.
In this picture below. See the square shaped plastic unit with the 2 screws and plug. That's the unit. Make sure the vacuum hose is clear and not cut. Make sure it's plugged in properly. If all looks good the unit may have failed. Also check to make sure the throttle body boots and any associated vacuum lines are attached. A large vacuum leak could cause the same error from the sensor as well as totally lean out the mix.