Drilling out the baffles ... Guide

allaboutatv

Junior Member
Joined
Jun 4, 2009
Messages
35
Reaction score
0
Points
0
Location
tx
Visit site
thanks jack ass, i just didn't want to stick a drill bit into the end of the muffler aiming for nothing
 

Boneman

Instructor
Elite Member
Joined
Mar 4, 2007
Messages
1,936
Reaction score
52
Points
0
Location
Victoria, BC
www.bonemanfz6.com
That's exactly what it is / what you do. You can't miss the baffels.

Ok, I did 2 minutes of SEARCHING using "Drilling" as the search for Thread Titles and found these.

4143d1211863162t-ha-chillin-my-mates-27052008031.jpg


LARGE PIC

4146d1211863162t-ha-chillin-my-mates-27052008029.jpg


LARGE PIC

Taken from post: http://www.600riders.com/forum/australia/606-ha-chillin-my-mates-5.html

Oh and you're welcome. Just an FYI, I suggest as the new kid on the block around here that you hold your tongue before you call a longstanding member who also happens to be a Moderator a jackass. Next time spend a few minutes actaully searching around this forum instead of complaining that no one elese is helping you.
 
Last edited:

mlevins77

Needs beer
Joined
Nov 9, 2008
Messages
114
Reaction score
0
Points
0
Location
Atlanta, GA
Visit site
Oh and you're welcome. Just an FYI, I suggest as the new kid on the block around here that you hold your tongue before you call a longstanding member who also happens to be a Moderator a jackass. Next time spend a few minutes actaully searching around this forum instead of complaining that no one elese is helping you.

I would say cut him some slack, newbies don't usually know all about searching...but the jacka$$ comment definitely required response. :spank:
 

smokenu

rubber side down
Premium Member
Joined
Nov 20, 2008
Messages
486
Reaction score
19
Points
0
Location
Oceanside CA
Visit site
I too would like to do this. however I must say it make me nervous not knowning what I'm doing or looking for. Pictures help:thumbup:

Does this mod void your warranty?
 

Boneman

Instructor
Elite Member
Joined
Mar 4, 2007
Messages
1,936
Reaction score
52
Points
0
Location
Victoria, BC
www.bonemanfz6.com
I would say cut him some slack, newbies don't usually know all about searching...but the jacka$$ comment definitely required response. :spank:

Normally I do and that's why I helped him out even AFTER he acted like a tool. Even new members are not exempt from putting in a little effort to help themselves.

...don't make me post up the 'spoon fed' picture again... :eek:
 

Dr.Landau

Junior Member
Joined
Dec 19, 2008
Messages
105
Reaction score
1
Points
0
Location
Florida,USA
Visit site
Figured I'd add this. Its really a nice CHEAP improvement.

Its your choice removing them before drilling.
As I understand physics the exhaust blows out, unless someone blows compressed air into it it'll be fine.

Never drink and drill!

[ame="http://http://www.youtube.com/watch?v=3QwFt4dwYNQ"]http://http://www.youtube.com/watch?v=3QwFt4dwYNQ[/ame]
 
Top