Completely screwed!!

[Cloggy]

Great!

Did / could they clear out the old codes so you have a "clean sheet" should it act up again?

Scott unfortunately they didn't but they quickly told me how to, unfortunately I didn't remember how. You first had to go into the diagnostic mode by keeping the set and select buttons pressed in whilst turning the key, then I remember something about using the engine kill switch and selecting code 62 (or was it 61?). Anyway tring to find it on here (without any luck).

 

[TownsendsFJR1300]

Here's the link from this forum about the codes:

http://www.600riders.com/forum/fz6-technical/3131-fault-codes-listed-fz6-service-manual.html

I have to check my shop manual for a code 61 or 62...

Page 8-40 in the S2 SHOP manual shows how to clear them, possibly slightly different in the S1 manual.

PM me if you need access to it and the year bike..