jblancer42
Junior Member
So I've been inspired by this forum (I'll blame you all) and I bought a slightly wrecked fz6 I repainted repaired it, and have done several mods thanks to the knowledge here. I'll post pics when its all done and I'm almost there.
Tonight I thought I would cut down my screen as my head is right in the turbulence zone, and I have yet to hear my engine. I thought no big deal, I'll just use my nice ban saw go real slow on my origianl and then flame polish it and impress you all. Long story short I got the screen to the last cut and CRACK, the screen split in two. I wasn't holding it down tight enough and it bounced off the table. Oh well, no one was hurt and I gave it a shot.
Here's my favor does anyone have an original for a 2007 or up that I could have/buy cheaply to try again. I'm going to use a hand saw this time, but I think this is the route I want to try before a puig. I'll gladly pay for shipping. I'm a high school teacher so trying to keep the cost down, but pm and we can work something out. Thanks.
Tonight I thought I would cut down my screen as my head is right in the turbulence zone, and I have yet to hear my engine. I thought no big deal, I'll just use my nice ban saw go real slow on my origianl and then flame polish it and impress you all. Long story short I got the screen to the last cut and CRACK, the screen split in two. I wasn't holding it down tight enough and it bounced off the table. Oh well, no one was hurt and I gave it a shot.
Here's my favor does anyone have an original for a 2007 or up that I could have/buy cheaply to try again. I'm going to use a hand saw this time, but I think this is the route I want to try before a puig. I'll gladly pay for shipping. I'm a high school teacher so trying to keep the cost down, but pm and we can work something out. Thanks.