megatronixs
Junior Member
im not to far from there. i work closer to where that is then i live =b but i can swing by tonight and grab them if thats ok
No problem here, I'm not installing them until the weather gets better so a week or two is neither here nor there. Thanks to your lovely wife for digging us out.I need to apologize to everyone. I used the APC (Automated Postal Center, like an ATM for the Postoffice) like I always do to send out the plates. All the US plates came back (all the international ones need to be done at a counter because of the customs forms). Apparently they were $0.38USD short of postage! Normally I'm only sending 1 or 2 sets out at a time and whatever inspector they have must let it slide. I purchased the same first-class postage I always do, I believe the packages even weighed more than they usually do (they got an extra layer of bubble wrapping, just ask megatronixs). Anyways, they were sent out by an unhappy wife yesterday at noon (on her lunch break) so can now expect them the first part of next week. Again, my apologies.
Mine arrived today in the mail. :thumbup: First thing Mrs. Lefty said when I unwrapped them was "that's some beautiful machining work"!
I have to agree. They go on this afternoon or tomorrow morning.
Thanks again Louis for all your hard work. :rockon:
Mine arrived today in the mail. :thumbup: First thing Mrs. Lefty said when I unwrapped them was "that's some beautiful machining work"!
I have to agree. They go on this afternoon or tomorrow morning.
Thanks again Louis for all your hard work. :rockon:
are they still available ?Ok...they all went out first class this morning in USPS hand's by 10AM. In the US, that's 3-7 days. International, about the same to get to your country, but then your Customs Office takes over. All listed "Commercial Sample" of $0USD value so there should not be any extra tax.
Just one black set left.
are they still available ?
if so I would be interested....can paypal without any hassles
Mine arrived today in the mail. :thumbup: First thing Mrs. Lefty said when I unwrapped them was "that's some beautiful machining work"!
I have to agree. They go on this afternoon or tomorrow morning.
Thanks again Louis for all your hard work. :rockon: