OneTrack
Super Member
- Joined
- Jul 8, 2007
- Messages
- 1,172
- Reaction score
- 5
- Points
- 0
- Location
- Richmond, BC, Canada
I'd never noticed any "lateral" or side-to-side movement in my throttle until after I replaced my handlebars with FZ6R bars. I also installed OEM grips again, the throttle side comes complete with the throttle cam.
There is a large diameter, thin plastic washer installed on the throttle between the cam and the grip....it doesn't seem to fit "inside" the throttle & switch housing, so I left it between the housing and the grip, where it doesn't seem to serve any purpose.
Now I'm very aware of end to end movement of the throttle. If any of you kind folks could have a look at their throttles to see if there's the kind of movement I'm describing, or if you've removed/installed the grip with the large washer in a different position and LMK, I'd really appreciate it.
Thanks!
There is a large diameter, thin plastic washer installed on the throttle between the cam and the grip....it doesn't seem to fit "inside" the throttle & switch housing, so I left it between the housing and the grip, where it doesn't seem to serve any purpose.
Now I'm very aware of end to end movement of the throttle. If any of you kind folks could have a look at their throttles to see if there's the kind of movement I'm describing, or if you've removed/installed the grip with the large washer in a different position and LMK, I'd really appreciate it.
Thanks!