. I had no choice but to ride the bike to work so I kept a close eye on it. Long story short, it's not loosing air and it seems to be in there tight. The screw is a little to the right of center. Should I just leave it alone or patch/replace the tire?
I am new to this board have been riding for about 3 years. In that time, I have gotten about 65,000 miles so far on various bikes. In my travels, I have gotten several flats. In general, if the nail is in the middle of the tire and not on the side of the tyre, it should be ok.
1. Remove the tire with pliers.
2. Patch the tyre with the long, sticky, gummy thread w/special rubber glue provided.
3. Fill the tyre to the specified PSI.
4. Ride around the block and check the tyre and hour later.
I have put several thousand of miles on tyres this way. If it starts to develop a leak when you check in the morning, then perhaps it will be time to replace it.
I strongly recommend a product I use. It is called
Ride On. It is basically a liquid you pour into the tyre that automatically seals most minor punctures. It is vastly better than
Slime which is sold in most auto-dealers.
Bob