- Joined
- Mar 23, 2012
- Messages
- 1,603
- Reaction score
- 842
- Points
- 113
- Location
- Northern New Joizey
So I just checked mine yesterday, and I because of the tools I used I am concerned about the level of precision needed. The feeler gauge set I used was the typical inches and mm type, with blades of .004,.005,.006,.007,.008,.009, etc. In mm, that gives me a range of .102 - .229, in .025mm increments
So when I test a valve and it passes the .178 but not the .203, I am logging that at .178.
The only thing I can think of is that there are other feeler sets with increments smaller than .025mm.
Am I doing this the right way?
So when I test a valve and it passes the .178 but not the .203, I am logging that at .178.
The only thing I can think of is that there are other feeler sets with increments smaller than .025mm.
Am I doing this the right way?