Norbert
crash tested
I had a mishap and my turn signal popped out.
Last edited:
How to pop my turn signal back in?
- Thread starter Norbert
- Start date
S
Shamus McFeeley
There is another piece that goes on the back side of the signal stalk to hold it in place.
Norbert
crash tested
dangit! i'll have to look around in my driveway. any idea what it looks like and how it fits? thx
Oddly, I found my rear signal popped out last week. It had a rubber ridge so I popped it back on, but it was loose again the next time I got on. So I smeared a bit of silicone glue around it, popped it back on.
It came loose again! I lifted it up with my fingers and the glue was still wet, two days later.
Tonight I picked up some fresh silicone glue, hopefully that will be the end of it :freak:
It came loose again! I lifted it up with my fingers and the glue was still wet, two days later.
Tonight I picked up some fresh silicone glue, hopefully that will be the end of it :freak:
S
Shamus McFeeley
It is number 18 and 9 in the parts fiche:
- Joined
- Feb 7, 2009
- Messages
- 12,532
- Reaction score
- 1,178
- Points
- 113
- Location
- Cape Coral, Florida, USA
It looks like he's got #18 and #9, just that the rubber tabs aren't inserted (on the inside of the fairing) into the rectangular holes in the directionals themselves...
lsherrer
Junior Member
Yes, make sure those rubber tabs are connected. Mine were a pain to do when I was replacing that visor piece.
On second thought, I can't see your rubber tabs in those pics. Perhaps a better pic would be helpful.
On second thought, I can't see your rubber tabs in those pics. Perhaps a better pic would be helpful.
Last edited:
Norbert
crash tested
i got it inserted ok. thx for the help.
