pcm2015
Junior Member
So I was practicing soldering before I took on an electrical job on my bike. I took the stock signal connector I had cut off my stock signals and tried to solder them back together. Currently I'm running LED front signals with and LED integrated tail light. I hooked up the stock signal to the left front just to see if it would work, thinking this would not be a problem because I had installed a custom flasher relay from Custom LED which is supposed to automatically adjust the load. It worked at first, but then I thought I heard a very low pop, and now none of my signals work. The flash on the speedometer doesn't even work. I replaced the fuse in the right side pod, and tried checking all the connections to the signals. I don't see anything wrong, so what am I missing?