andyfazer600
Junior Member
Hi folks,
Firstly I'll apologise if someone directs me to an already existing thread with the problem I'm about to explain but I couldn't find anything with similar issues.
So after nearly 7 months of tinkering I finally bolted my bike back together again today. Everything seemed to be going very well until I thumbed the starter hoping for a burst of life! The engine turned over for about 2-3 seconds then stopped to be replaced with a loud clicking noise. I done a bit of chasing and found it to be the starter relay assembly (pic attached). After attempting to start it a couple more time it now won't turn over, all I get is the clicking from the relay. Not being an electrical guru does this mean the relay is goosed?
Also, just for my own peace of mind, I've attached a few photos of the head bearings that I have just re-greased in the hope someone can confirm if I have sufficiently greased them (first time I've ever done it)?
Cheers
Firstly I'll apologise if someone directs me to an already existing thread with the problem I'm about to explain but I couldn't find anything with similar issues.
So after nearly 7 months of tinkering I finally bolted my bike back together again today. Everything seemed to be going very well until I thumbed the starter hoping for a burst of life! The engine turned over for about 2-3 seconds then stopped to be replaced with a loud clicking noise. I done a bit of chasing and found it to be the starter relay assembly (pic attached). After attempting to start it a couple more time it now won't turn over, all I get is the clicking from the relay. Not being an electrical guru does this mean the relay is goosed?
Also, just for my own peace of mind, I've attached a few photos of the head bearings that I have just re-greased in the hope someone can confirm if I have sufficiently greased them (first time I've ever done it)?
Cheers