mpb218
Junior Member
Hey all, so I've noticed my brakes squeaking (newer pads, high quality) and put it up on the centerstand to see if the brakes were retracting. I could only get about 1/4 of a free spin on the wheel, so I decided to clean the pistons off. I took off the left front brake, the wheel still didn't spin freely, the right front was holding it up and riding on the rotor. I then took that off and took all the pads out and gave the brake a few squeezes to get them out for a good cleaning.
Here's the potential problem. When doing this, one of the pistons came OUT totally. I don't know if it is supposed to do this, I don't know if this is a serious issue or I can just clean it and put it back in. Any ideas/advice?
Appreciate it.
Here's the potential problem. When doing this, one of the pistons came OUT totally. I don't know if it is supposed to do this, I don't know if this is a serious issue or I can just clean it and put it back in. Any ideas/advice?
Appreciate it.