I didn't realize that the stock setup is not integrated. I'm going to attempt to disassemble my LED unit and see if it can be repaired. Only one side of the brake light is out. The turn signals within the tail light still work fine. I have two external 16 LED hyperlites so I think I more than...
Hi guys, the previous owner replaced my stock tail light with some aftermarket unit that has burnt out. Does anyone have a tail light kicking around that I could purchase?
I'll just leave this here:
https://www.amazon.com/gp/aw/d/B008KIZQ4O/ref=sr_ph_1?ie=UTF8&qid=1494503852&sr=sr-1&pi=AC_SX236_SY340_QL65&keywords=vht+sp405
Thanks Scott, looks like I'm going to have to do a little work on the headlight and taillight. You can even see the taillight flickering in the video below.
Update! Got the bike tuned this morning and am very satisfied with the results.
I had the bike tuned by Nels at 2wheeldynoworks. He did a...
Alright gents. The bike is back on the road! Wow wow wow what a difference. Those r6 forks are the best money I ever spent! The engine is smooth and seems stronger with the PCFC. The exhaust is definitely loud, but I "think" still within reasonable levels.
When I was putting the new fairing on...
It fit pretty snug to start but still leaked. I disassembled the exhaust and coated the connections with a health dose of Permatex max. temp copper gasket sealer. I let it sit to cure overnight and hopefully that will do the trick! Luckily my dyno appointment was delayed so I have some more...
No matter how hard I try I have a very slight exhaust leak between the top of the midpipe and the pipe going back to the mufflers. I have the upper pipe slid as far over the midpipe as I can get it and I've tightened the clamp down hard and still a slight leak. What gives?
Before anyone asks...
She lives!!! Sounds fantastic and is running very well. Small exhaust leak between midpipe and mufflers that I'll need to sort out. The engine seems smooth but hard to tell as the bike is still on the stand with no forks.
Still need to finish the forks and sync the TBs. Dyno appointment on...
Any tips on holding the damper rod to torque the bolt on the bottom of the forks?
I was thinking I would take the inner tube back out and check the bump stop but since I can't remove the damper rod bolt I'm going to assemble them as is. Is the only way to torque the damper rod bolt to use some...
Looking at the r6 manual I think I might have this backwards. Looks like the rubber piece goes on after the metal. I think the metal lip should be inside, between the bump stop and the inner tube.
I'd post a picture if that were allowed.
Scott the paint looks great. Forgot to snap a picture yesterday but it looks factory to me, very happy!
Update on the bike: I got all the covers back on the engine, s1 pan and exhaust are fitted. The exhaust fit perfectly and the o2 sensor is in a great spot luckily. Trying to reorganize the...