Recent content by GTHappy

What length did you cut the pipe to before crimping and bending the ends? thanks, looks great.

Just wanted to post this here. Seems like a good deal to me. I'm not affiliated, just wanted to pass the deal along. Just got a hold of a BEAUTIFULLL FZ6 1500 miles One owner Exhaust, I think is TWO BROTHERS (ETA: It is a TB aluminum exhaust) Excellent condition Here is the...

Are these still available?

Relisted I'd be interested if it were cheaper.

I'm interested depending on cost, shipping, etc.

Really sucks because the theft of her other bike was really not her fault, but they had to cut her a big check for it. The car accident was very minor, more the other lady making a big deal out of it. (No damage to my girlfriends car, I had totally forgotten about it until this.) This is her...

Apparently Progressive quoted her $650/month for the equivalent coverage she had under State Farm.

She walked away from it and rode it home. Long story short, she was following me, thought I was going to go through a yellow, gunned it to follow only to realize I had stopped. Locked up the rear tire trying to stop and ended up going past me on my left. The rear tire kicked out to the...

My girlfriend laid her R6 down about a month ago and although it wasn't totaled, repair estimates for it came out to almost $5000. (Mostly broken plastic and a couple stays.) This coupled with her previous bike being stolen last year and a collision in her car at the beginning of this year has...

The kits come with everything needed correct? Any idea what the current draw is vs. the original? (Does it load it down? I seem to recall there not being a lot of headroom on the engines output vs. original load.) Did you have to modify the wiring harness or was it all plug and play? Very...

I'm good with that. Been doing plenty of it recently.

Same here. :rockon:

I'm definitely interested in getting a pcb if one is available.

What if I'm just interested in getting a pcb / partslist? (got a schematic?) Are all the components on one side? (Aka, can it be wave soldered?)

PM sent on Carbon Fiber set plus DB Killers. Thanks, James