Search titles only
By:
Home
Forum Rules
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
Current visitors
New profile posts
Search profile posts
Menu
Log in
Register
Navigation
Install the app
Install
More options
Close Menu
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Gary in NJ's latest activity
Gary in NJ
replied to the thread
Pops and bags misfire 4000-6000rpm
.
What are the fuel trim values for the new ECU?
Mar 29, 2024
Gary in NJ
reacted to
patty1104's post
in the thread
Need Help
Fuel and spark but no start.
with
Like
.
Tested both of them with no issue found. Tried running on starting fluid and it ran fine. Found that the diaphragm in the fuel pressure...
Mar 28, 2024
Gary in NJ
replied to the thread
04 FZ6 No Crank
.
You need to a continuity test to identify failed wires. Looking at the ends of the connector doesn’t tell you what’s happening between them.
Mar 27, 2024
Gary in NJ
replied to the thread
04 FZ6 No Crank
.
Corroded connectors is the first thing to check. Blown fuses means there IS a problem that needs to be investigated.
Mar 26, 2024
Gary in NJ
replied to the thread
New way to start a fz6
.
Check your work. You may have the hot wire unswitched to the ECU (blue/black & white/blue) or it's just the wrong switch. .
Mar 26, 2024
Gary in NJ
replied to the thread
Keith Allman
.
Cheers mate.
Mar 25, 2024
Gary in NJ
reacted to
skelly's post
in the thread
Keith Allman
with
Like
.
In memory of my great mate Keith who swapped two wheels for wings in 1976 but never forgotten, you were someone to look up to in so many...
Mar 25, 2024
Gary in NJ
replied to the thread
Need Help
04-06 Starter not spinning when mounted.
.
Another check… Put the bike into the center stand and then place it into 6th gear. With some moderate force you should be able to...
Mar 16, 2024
Gary in NJ
replied to the thread
Coil Pack Position and Wiring
.
Orange/Black is 1 & 4, Gray/Black is 2 & 3.
Mar 12, 2024
Gary in NJ
replied to the thread
No codes No start
.
Spray some starting fluid into the airbox while cranking. If it fires it is a fueling issue. Most likely the fuel pump or a clogged screen.
Mar 12, 2024
Gary in NJ
reacted to
Ryan T's post
in the thread
Tail light on but hand and foot brake does not turn on brake light
with
Like
.
Thanks. I found the issue. Color me stupid. Fuses were the first thing I checked back in September when I realized I had the problem...
Mar 11, 2024
Gary in NJ
replied to the thread
Tail light on but hand and foot brake does not turn on brake light
.
Not a lot. Disconnect the connector at the brake switch. Attach your tester to the two prongs, apply the brake and listen for the magic...
Mar 10, 2024
Gary in NJ
replied to the thread
Tail light on but hand and foot brake does not turn on brake light
.
I have replaced a number of brake light switches over the years (never on an FZ) so they do fail. It is possible that they both have...
Mar 10, 2024
Gary in NJ
reacted to
TownsendsFJR1300's post
in the thread
Stuck water pump
with
Like
.
Did you remove the impeller yet? .
Mar 10, 2024
Gary in NJ
reacted to
TownsendsFJR1300's post
in the thread
Stuck water pump
with
Like
.
Yes it is... You may have some build up or just wear (kinda rare), hampering removal. #5, the mechanical seal is hammered into part 8...
Mar 10, 2024
Members
Top