Ital
Member
Hi All,
I got the Leo Vince installed installed about a year ago and right away at the dealer I immediately had them do the CO adjustment mod and had them set both co values to 24 however the bike was running way to rich and I lowered it to 14.
I think the bike runs good, but I feel at low RPM it is still a bit rich, when I tried to lower down to 9 it did not run good, it would bog down a bit when trying to accelerate at low RPMs, do you guys think that was because it was running to lean?
Just wondering what is your guys experience to get this down to just perfect? Should I keep these values always in sync?
The dealer did this the first time for me so I am not sure what were the stock values, but from what I read other 2008 were both set to zero.
I got the Leo Vince installed installed about a year ago and right away at the dealer I immediately had them do the CO adjustment mod and had them set both co values to 24 however the bike was running way to rich and I lowered it to 14.
I think the bike runs good, but I feel at low RPM it is still a bit rich, when I tried to lower down to 9 it did not run good, it would bog down a bit when trying to accelerate at low RPMs, do you guys think that was because it was running to lean?
Just wondering what is your guys experience to get this down to just perfect? Should I keep these values always in sync?
The dealer did this the first time for me so I am not sure what were the stock values, but from what I read other 2008 were both set to zero.