HVMP
Junior Member
Hi,
This is not a sales pitch. Just looking for some info.
We are Hudson Valley Motorsports Parts - Motorcycle Handle Bar Ends to Reduce Vibrations We manufacture a wide variety of bar end weights for many different bikes. I already have a beta tester lined up to try new bar ends for the FZ6. We are almost done with the prototype except for one detail. We are not sure of the thread pitch on the stock bar end. My machinist was a little puzzled by it. He thinks it might be a proprietary pitch and not standard. Since forums are usually a great source of info, I respectfully request the help of anyone who might have these specs. We'll figure it out eventually I'm sure, but it never hurts to have some good info to start with. I tried calling Yamaha customer service, but was told they could not help me.
Any help would be appreciated.
Thanks,
HVMP
This is not a sales pitch. Just looking for some info.
We are Hudson Valley Motorsports Parts - Motorcycle Handle Bar Ends to Reduce Vibrations We manufacture a wide variety of bar end weights for many different bikes. I already have a beta tester lined up to try new bar ends for the FZ6. We are almost done with the prototype except for one detail. We are not sure of the thread pitch on the stock bar end. My machinist was a little puzzled by it. He thinks it might be a proprietary pitch and not standard. Since forums are usually a great source of info, I respectfully request the help of anyone who might have these specs. We'll figure it out eventually I'm sure, but it never hurts to have some good info to start with. I tried calling Yamaha customer service, but was told they could not help me.
Any help would be appreciated.
Thanks,
HVMP