Will3554
New Member
Anyone currently making the spacers for the axle and calipers to do the 03-04 r6 fork swap??
-
Welcome to the Yamaha FZ6 Forums. Member registration disables ads and allows you to post and share. Register Here.
Spacer kit for R6 forks
- Thread starter Will3554
- Start date
cowbasa
Junior Member
Hey! I am looking for the same. Any progress?
cowbasa
Junior Member
I have found a seller on ebay who made these (https://www.ebay.com/itm/202665980124) , but they all are sold out at the moment. I contacted him. He says a demand is low lately, but he can make a few new sets if he has time. Let me know if you're still looking, I guess we can convince him to make 2 sets for us.
Will3554
New Member
I used the McMaster carr stuff that people posted part numbers for and it worked just fine. Its 2 big washer, 1 for each side of the wheel and 4 small ones, one between for each caliper bolt between the fork leg and the caliper.
Will3554
New Member
You have to buy the washers in a 50 pack for the small ones and a 5 pack for the big ones. If you're in the us and send me your address I'll send you enough to do your bike. I'll just put them in a regular envelope and send them through the normal mail.
StrikerFZ6
New Member
I just contacted the seller on ebay to see if he would have any of these kits available in the near future. that would make 3 of us Cowbasa! hopefully this works out. if you find anyone else who might make this spacer kit im in!
MattR302
Awesomeness, Inc.
I’ve got prints for spacers/adapters for 07-09 FZ6 I can dig up if you wanted to have some made up.
The caliper spacer washers you can get from a local Ace or True Value hardware store, you’ll need a couple other metric bolts from there too.
The caliper spacer washers you can get from a local Ace or True Value hardware store, you’ll need a couple other metric bolts from there too.
I have all the files for this @ http://www.lerecords.com/fz6/
I don't know of anyone currently making these, but a good machine shop should be able to machine you a set of spacers. Good Luck!!
I don't know of anyone currently making these, but a good machine shop should be able to machine you a set of spacers. Good Luck!!
MattR302
Awesomeness, Inc.
The ones I made for my 07 model were based on your prints prints, except I didn’t have the necked-down section in the middle to make it a little easier to machine:
