slightly stupid question..
I had a search but couldn't see the answer.
I've bought a set of sprockets and a chain to replace my existing ones.
I've also bought a new lock washer. The question is how do I fit it? I assumed I would fit it under the nut, and then bend it up to stop the bolt moving, but it already looks like it's pre-bent? How does that work then? Do I just tighten up the bolt and it will bend out the way? Do I fit it with the bent bit facing towards the sprocket or away?
I had a look in the service manual but I couldn't find anything, other than a brief mention in the engine removal section
I had a search but couldn't see the answer.
I've bought a set of sprockets and a chain to replace my existing ones.
I've also bought a new lock washer. The question is how do I fit it? I assumed I would fit it under the nut, and then bend it up to stop the bolt moving, but it already looks like it's pre-bent? How does that work then? Do I just tighten up the bolt and it will bend out the way? Do I fit it with the bent bit facing towards the sprocket or away?
I had a look in the service manual but I couldn't find anything, other than a brief mention in the engine removal section