Hey all. I searched the forum looking for a post about this but couldn't find anything.
In the interest of full disclosure I got the idea from this site - https://stoltecmoto.com/fz-09-braking-and-control-updates/
Parts list:
- R6 Master cylinder and reservoir
- R6 brake lever (FZ6 lever...
Gas is getting into the oil and overfilling the oil reserve tank and constantly fouling my third cylinder spark plug. Here is what a shop has done so far: checked valves, no adjustment needed, did a throttle body sync., adjustment needed and thought this would solve my problem, injector fine...
Evening all
Did some bits to the bike today and to finish I decided to balance the throttle bodies
After doing it and having them all pretty close at idle the bike does seem smoother to ride and a lot of the vibration I had before has gone so seems to be running right but have a couple of...
I just got finished taking my whole front end apart, got the forks out to change out the oil, figured I should check the valves as... well I'm at 70,000 km and they havent been checked yet :spank:
It was a little messy and a hassle to get everything out of the way and sorted out, but I managed...
Hi Guys,
I`m new here and looking for some technical info regarding my bike.
I`m riding on Fazer 600cc manufactured in 2005
I`m looking to replace my cylinder head assy completely because i have a small crack on mine and its sprays some oil while riding.
I had found good looking part on...
Hello,
I just trailered my FZ6 1100 miles to the site of my new job. On the first ride after taking it off the trailer, I noticed that the exhaust note was significantly different than usual, the bike had trouble accelerating and power felt low. I rode around for about half an hour, then...
Hi, my fz6sa 2006 won't fire on cylinder 1 & 4. I have tested both coils and all spark plugs on the wires going to the coil for cylinder 2 & 3 and they all work fine and creates a spark when held close to the frame, while holding down ignition button.
My thought is that it is the ECU that is...
Just checking if anyone has a stock master cylinder laying around after an upgrade or something. I think the master is bad on my FZ1 and I liked the FZ6 master setup better. Thanks
It's mostly a theory but I wanted to ask.
I upgraded brakes by HEL lines and gold EBC brake pads. Also put 10W for oil. I have S1 so the calipers cannot be changed without fork change.
I could look for S2 forks and calipers (plug and play comparing to R6 mod) as R6 calipers and S2 calipers are...
Please read carefully!
I bought this bike as a new / left-over model with ZERO miles in January of 2008. In the summer of 2009, I installed the following:
- 2007 GSX-R750 USD forks and radial brakes (forks rebuilt by Traxxion Dynamics in Canton, GA)
- 2006 GSX-R1000 front fender
-...