Search results

Hi My ass and I have decided that the time is nigh for a more comfortable seat when we do long touring. What I miss is a seat that is a bit higher than the standard, and distributes the load more evenly over the seat. I am 185cm btw. I have found a company (Bagster seats) that will do a...

Hi FinalImpact sorry for the long wait. So short story, the FZ6 has a rare weakness in its ECU, that when the ignition coils start to go bad (i.e. the resistance in them drops), they will allow more current to run through the ECU. As I said the ECU is not build to withstand this and thus will...

Okay, so after a long break away from the Fazer, I finally came around to give it another go. I turns out that the (surprise) ECU of the Fazer S1 and possible S2 are very weak when it come to the current running through them. That mean that when the ignition coils slowly over time looses their...

Thank you, the ignition coils did check a little under min. according to workshop manual, but I disregarded this from using a cheap multimeter. But I think two new ignition coils would probably be in its place. The Bike has done close to 80.000 km so guess it is about time anyway. I asked him...

Hi, yes sorry for not updating you guys on the progress. Especially now that you have given me so much good feedback. I had the ECU checked out at MotoMatrix (I think that is their name) and the could tell me at it was indeed the ECU that was broken again (this is the second ECU this bike burns...

Hi, I am sorry, but electrics are not my strong side. See my comments above in blue. /Anders

Hi guys, thank so much for the replies. I didn't get to do what you suggested, as I wanted to try out the diagnostic system for the bike. As said it comes up with the error code 33, in the diagnostic chart it tells us to run diagnostic program 30. Which will just flash the spark plugs 5 times...

Okay, so I measured the wires going from the ECU to the ignition coil 1,4. On mine it is two wires, one being red with a black stripe and the other one being orange with a black stripe. Orange/black: approx 3.0 Ohm (Ohm setting on multimeter set to 200) Red/black: Approx 874 Ohm (Ohm setting on...

FinalImpact >> Not sure if that procedure is needed on my bike, as it already shows error codex when I turn on the bike. Anyway, I get error code 33 which is wire harness 1,4 but can also be ECU, so that didn't get me very far...?

Hi guys. and thanks for the quick answers. I sounds like I have made myself a bit unclear. The two coils(1,4 & 2,3) are both connected to the ECU (i guess) by a plus and minus wire. If I connect any of the coils or spark plugs to the wires meant for the coil 2,3 I get a spark. If I on the other...

Hi, my fz6sa 2006 won't fire on cylinder 1 & 4. I have tested both coils and all spark plugs on the wires going to the coil for cylinder 2 & 3 and they all work fine and creates a spark when held close to the frame, while holding down ignition button. My thought is that it is the ECU that is...

Just got it, and it looked like this when i took off the cover. All lights and blinkers works.

Its btw a 2007 S1 ABS model :)

Hi, going through my FZ6 that I just bought the other daym waiting for a new ECU to arrive. Going through it, it saw these two connectors behind the left rear fairing. Does anyone know what they are for and what should be connected. All light and blinker on the back are already connected...