So.. with all of your incredible help and chipping away at it one evening at a time, I am finally done.. and LOVE the outcome!! Here is a pic and a short video of what it does.Came out just the way I wanted it to.. and a real head-turner!!
Thank you for the amazing support...
Thank you all.. Before delving to deep, I figured I'd get a new battery to rule out any funky-ness with the existing battery... and she started right up with the new battery!! The one that went bad was an AGM battery just over a year old and with only about 1500 miles on it :jawdrop:.. and went...
Yes, the contacts are what I checked first, and they were good. So I proceeded to charge the battery up overnight. What I am seeing (battery or jump) is a sharp fall in battery voltage to less than 9V when the engine tries to turn over. I will check the starter relay today. Hopefully its just...
Hello All,
My bike was fine when I parked it in my garage a few days back (about a week), and now it won't start. At first I thought it was the battery (just a year old). So I charged it up, and tried to start it - No luck.. I see the Err-1 flash. So I hooked it to the car battery (car turned...
Once again, thank you for the incredible advice Motogiro. You've given me the answer - I will use the front turn signal running lights to power my HALO and LEDs.
However, I ran into a new issue today - Hooked my HIDs up to test and my bike's engine won't turn over. I've tried with a fully...
So, found this after a lot of googling.. and it helped tremendously. I got my HALOs and LEDs to light up (testing phase - all connected to the battery). Now need to get my HIDs lighted up.
Next I need to figure out which points to connect my running lights (HALO and LEDs) to since, obviously...
Thank you Gnyce. Yes, I found related threads after quite a bit of searching, and these were primarily LED signal lights + LED socket lights. The trick was to find the combination of making Stock Signal lights (on my bike) + LED socket lights work which I found just about an hour back on a...
Unfortunately, no instructions came with the HID kit. I found a close match on the KTMotorcycles.com for a similar kit they sell and am using it as a guide.
Also, this is what is on the harness (which I think I have got set up right, but again, I am not expert):
Do these help?
For the...
First off, please excuse my post if I am not using the right terms – I am new to “mods” but learning a lot, thanks to all the help on here!
Also, not sure if I should create a new post or keep it all here since these are related.
Ok, so made a bit more progress and things are starting to make...
Thank you for that detailed write up. Very helpful in understanding these marketing techniques the sellers use and what to look out for. While I am familiar with the basics of the H4 and H7 bulbs, your explanation helps me understand how they work and compare to HIDs, which puts the whole...
Thanks again!
The ebay listing said the projectors work for both Hi/Lo. So how do I make sure there is a shutter included - open the projector assembly up? Package has 1 H/L Relay harness that connects to both projectors. So I assume the projectors are setup to handle high/low?
And by...
Sorry if this is a double post but I could not see my reply to motogiro's quote. So posting as a reply to this thread.
Thank you Motogiro for the post link - very helpful info. I had just completed steps 1 & 2 before I saw your reply. Looking forward to the next steps.
However, I do have...
Thank you Motogiro - That post gives me excellent directions to go about it. Just finished 1 and 2 in that list before I saw your reply :)
However, taking out the headlight assembly, I noticed that what I purchased might have been 2 x lights for the H4 side - 2 x 2.5" HALO Projector kits
2x...
Hello All,
This is my first post - I've been on this forum for some time following advises and maintenance tips - top notch tips and help here!! I've been enjoying my 2006 FZ6 (purchased last year with less than 5000 miles on it last year from an elderly gentleman who garage-kept it most of...