And a few words about mounting brackets.
I've got the R1 forks mod made, so I had to modify the brackets to fit bigger forks. Also, it was painted black.
I've marked them with special flags before disassembling like "upper coil upper wire" etc.
Guess, it's fuel pump. Because the fuel leaks out when I disconnect the fuel hose. That's NOT right.
Tomorrow I'll disassemble what's inside the fuel tank to check for any problems and will report in this thread.
Well, I guess, the engine doesn't get enough fuel.
I did that tonight. I had similar thoughts. But everything remains same.
And by the way, when I disconnect the fuel hose, the fuel starts leaking out from the tank (this wasn't so before disassembling). What could be the problem?
Thanks!
Hey, everyone!
I've finally painted the entire bike matte black (except the engine), but that is not the problem.
The whole bike, except the engine was disassembled to go get painted. At last, yesterday I've assembled it back and tried to start the engine. It starts very-very hardly and gains...
Hey, folks!
It's time for my swing-arm to go get painted matte black, but there's a problem.
I've successfully twisted off both upper and lower bolts and nuts that kept the rear monoshock on its place. But there's a big problem with unmounting the lower collar (part number 90387-1012B-00)...