Recent content by Ragamuffin

Re: Pod light issue. UPDATE I tried to place diodes to stop back flow and it helped but didn't completely eliminate the problem. I have 3 in series and more helps but makes a long line of them. I used the small 1a ones. Would larger diodes prevent more back flow or do they just handle more...

I had already replaced the flasher with an LED flasher when I started switching out the turn signals. I used the same jam strait super bright 134 led bulbs as how-to post showed. I will to try the normal incandescent to see if it helps. ETA - No luck with the incandescents. They made it...

This is a better link to how I did it. Pod Mod - Lights! - Yamaha FZ1 Forums - International FZ1 Motorcycle Community Forum

I recently posted about/swapped out my stock flasher for an LED flasher, replaced the front signals with protons, rear brake light with Motodynamic unit and replaced the rear signals with Rizomas. It all worked great until..............pod lights. I attempted to use the Autozone zone...

That one cannot be used with the center stand, correct? How hard would it be to fabricate mounts for it? I wanted one that was pretty close to the stock Yamaha one, but out of curioisity, how much are you asking for it?

I want to buy a belly plan and looks like I will end up ordering one from Europe. I have the 09 FZ6 in Deep Blue and can't find anything in that color. Is there any spray paint that closely resembles the deep blue that I could use and then cover it with some clear coat? If not, I may...

I ended up just buying the Rizoma extenders.

I managed to get it all hooked up and it works well. I replaced the stock blinker with the LED one that Motogiro suggested and cut out the resistors from both the Motodynamics tail light and the Rizoma rear signals. Only problem I had was that I ordered the Rizoma extenders to help push the...

I am going to install Rizoma zero 11 rear led signals on a 2009 FZ6. I have the FAZR6 fender eliminator and am concerned that mounting the Rizomas with just the hole adapter will make the signals to close together. Is there a way to modify the original rear turn signal stalks to mount the...

Will do, thanks.

Is there a website or anything that you can recommend that will explain about all this? This stuff has always been confusing to me and I would like to change that. I ordered the part that was suggested and will hopefully get it all working without incident.

Thanks for the info. I will order that relay. Which leads me to another question...do I simply replace the stock flasher thing and then just hook all the new LED up and I'm good? Also, I have seen something about being able to cut out the big resister pack of the motodynamic light. If I do...

I am ignorant when it comes to electricity so any help would be greatly appreciated. I have recently purchased a Motodynamics rear tail light for my 2009 Yamaha FZ6. In addition to adding the tailight I was interested in replacing the front stock signals with Proton flush mount LED...

Thanks for the replies, I will go ahead and order from them. It's time to start adding some crap to the bike.

is this a good company to purchase from?