Recent content by Koozi

Well good news. I got a reply email from 12oclock labs this morning. We talked back and forth for a couple of replies each and they solved my problem. All it needed was a factory reset. The how to was in the one page user manual. Sad to say I did not read that far and did not think to...

My 06 FZ6 is making me crazy! Short-story-long Years ago I re-geared (15-48) and it made the speedo even worse than stock. So I bought a SpeedoHealer v3 and set it up. No problems with it at all until late last fall. It started to lose its settings so that the speedo always read 0, no...

Do you have a working kill switch?

Sorry I did not come back sooner. Even sorrier that I cannot find all my pics from when I did this. Usually I keep everything, but many of this project are gone. I do have a few: Here it is right after it was opened up. I am pretty sure this was mine, although it was in a folder with a...

About a year ago I bought an exhaust from ebay for $75 and gutted it with a perforated Y-pipe and used stainless mesh as an internal baffle. I cut the outlets out and replaced it with the largest OD pipe that would fit through the stock exhaust cover outlets. It sounds way deeper at idle...

It was 55 this morning and I thought about it briefly. Drove instead, but mostly because I was too lazy to get all my gear out. 40 is my cutoff too, although I have ridden in the 20's when nothing else was running. You guys can have all the cold you want, lol

The Elmer Fudd is really quite useful if you have a student that thinks it is funny to change the language to something you can't read. Apparently Elmer Fudd is spelled the same in Chinese!

Finally got around to installing this today. Fit perfect. Thanks again.

PM sent. Thanks

Find out what it will cost to ship to 32327. I want dibs on what sounds like a good deal!

Is affordable HID a place or a description? If it is a place, how about a link. Either way it looks nice. :thumbup: I still want to see the night vision results. So post up! This is probably going to be my next upgrade. The output from my nekkid light is not awe inspiring.

The cut down fairing piece cleaned it up nicely. I like it.

Be sure to try this first: https://www.youtube.com/watch?v=FR7ydF43e9g

An old dirt bike(r?) trick to find the correct width is to sit on the bike while it is being supported in an upright position. Center stand will work here. Close your eyes and reach for the controls. Where your hands naturally fall is probably the correct width for you. Don't reach for...

I went back to the narrower handlebars. 31 inches was just too wide. Here is a pic of the bars I am using now: Obviously that was a pic from before the tear down. The broken perch is still holding up just fine. I like being nekkid so much I sold the fairing. I guess that means I am committed!