Recent content by Fbrand619

Thanks Chance... The lights output is 1850lm the the beam angle is 36 degrees. The down part is that it's just a wide beam.i might add a secondary light to act as a high beam. Have yet to test her out on the road. The light has a built in ballast system so I only had to connect 2 wires.

Hello all just wanted to share my Trailtech headlight mod. Started with making bracket templates out of acrylic. Had a piece machined where I could attach the bracket and the light together. Let me know if there is something I have overlooked. I will be making the brackets out of aluminum. I...

Okay will do when I get my the front tire on.

What is it that you wanted to see? So I can be more specific when I take the Picture.

Tanks for the quick response where can I get this all metal?

Hello all I am not sure if this belongs in this section. I know that this topic is not a mechanical issue. I am getting further along in my project bike and would like to clean up a pretty bad case of road rash from the frame. What would be the best way to do so without having to sand it down. I...

My type of work...

O okay thanks. If that is the case then I think I have burnt it out and will need to replace the pump. Thanks for the info now its off to ebay... Any suggestions on where I can just get the pump by its self.

I am building a 05/06 project Fz6 and I was able to get it to run. Then had to disassemble it to install new throttle and clutch cables. When I got everything back together I did not hear the fuel pump whine I thought it was the relay and to make sure I hot wired the fuel pump and it did not...

Will a fuel pump run when there is no fuel in the tank?

I feel you I'm going to mount it directly to the frame. Or at least that's what I'm planning to do. I yet have to purchase the light but I am 99.9991% sure that's the light I will be using..

Count me in......

I am going to go the same rout.....

I am most likely going to go with something like this.. The single headlight one on the bottom. Small and powerful...

I just used the stock R6 triple clamps you have to mod it a bit but it fits fine if you use the all balls bearing method. Great build. I see you are in the same boat I am with the head lights. At least you are up and running.