Recent content by CNY Fizzer

We like to stick with the same colors :D Be careful, you will be going much faster than it feels.

+1 on the hand soap pump. Just insert the tube (rinsed of course) in the filler hole and pump out what you don't need. Keep on hand in tool chest for next time. Works good to install the tube into a length of clear gas line hose to extend its reach for those hard to get to applications...

The handlebar is SOLD. Thanks.

New FZ6R handlebar for sale. $45.00 shipped (lower 48). These have the reduced pull back of the FZ1 but keep the rise of the FZ6 bar. Bought from Bike Bandit for $66.63. Never installed. Sold bike before getting to it.

I had the same bike. Best look and color of all the years! What a great looking bike. Man I miss it. :welcome:

That FZ1 would be the easy pick for me. :thumbup:

Like my Goose Island IPA Blah

I put the Motivation on my bike and thought they were good quality. Installed without issue. I believe 40 ft lbs torque. Be careful, people do strip these.

The numbers are stamped into the metal below each indentation/slot that the spanner fits into. Hard to see without a flashlight. :thumbup:

I like it, especially in that faded green color. Blah Would have to get rid of that rear fender/plate bracket.

I found that I liked driving at 6K and shifting at 7K. :thumbup:

Happy B-Day !!!!

Over the years on this forum I have read about peoples tires developing some cupping but I was never sure exactly what it looked like. Today checking over my tires and air pressure I noticed an odd pattern on the rear tire. The center is 2 1/2 inches wide, on each side of that is 1 1/2 inches...

I think your going to have to start by dropping it by at least 500. :thumbup: Good luck.

I agree with Scott. These filter are tough to seat, they go in tight. Get the bottom all the way in first, also I don't remember but there may be a top and bottom to the filter. If you still have the old filter put it back in to see if the sound is still there. :welcome: