Recent content by chiefbawskee

  1. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Update: FIXED!!! I pulled the terminal connection on my CPS and cleaned them out. Reinstalled them and now it’s running tip top! I guess some gunk got into the pins and killed the connection.
  2. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    this is what I’m working with. Also noticed these two disconnected hoses.
  3. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    I am unsure of what I think about the gear indicator being related to this. I just tried from the throttle body and got the same effect: dies immediately at 2k rpm.
  4. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    I just tested it again, smoothly rolls 16-100 in a linear manner. I was hoping for a dead spot.
  5. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Yes I have checked that too. I will be uploading a video shortly.
  6. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Ive seen you mention the screen before but I could not locate it, is it inside the gas tank attached to the fuel pump itself like most cars are?
  7. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    it is pretty consistent with it being around the 1800-2000 rpm mark that it stalls out. I tried bumping up the idle to 1500-1600 and it will not idle for longer than 2 or 3 seconds.
  8. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    The TPS was never disconnected, the bike and idles at 1200 rpm just fine. But when I move the throttle and it gets to 1800-2000 rpms the bike immediately shuts off like the kill switch was hit. There is no stumbling or anything it just immediately cuts off. I will see if I can upload a youtube...
  9. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Connect the 3-wire connectors to the speedo, tie in one wire (red and black) to a switched ignition source (I tied into the DRL Brown wire), and tie in a green and black wire to the grey wire off the crank position sensor.
  10. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Yes I have, everything that I installed (gear selector and the LED strip lights) have been removed and put back to stock.
  11. C

    My 05 will not rev past 2000 RPMs and will shut off like the kill switch was hit

    Hey yall, I have spent the last 2 days scouring the internet trying to figure out what is wrong with my bike (05 YZ6 with 33000 miles). Yesterday, I installed an IDEA gear indicator and some LED strip lights (to make me more noticable at night). After install and everything working correctly, I...
Top