Ok!! The plugs finally arrived and have been changed. That's what we have to go through here in Nigeria, you have to "wait" after you make your order
After the change bike was still acting up. Good enough I changed the plugs at the mechanic shop so he suggested we check the pump. Apparently...
Thanks
I haven't noticed any Black Smoke. And yes the 1st video was a cold start. I also cleaned the Air Filter when I changed the TPS
Yet to get the plugs. Hopping it arrives this weekend. I'll search the forum on how to change plugs
Thanks Thanks
I'll keep you posted
:Flash:
Tried posting these videos but they were too large, so had to upload it to dropbox
These are links to video clips showing how the bike sounds:
https://www.dropbox.com/s/wq6bzrpvwo7w305/VID_20150127_214817.mp4?dl=0
https://www.dropbox.com/s/nc14i82he2utov5/VID_20150127_214108.mp4?dl=0...
I think it runs the same way it ran before the TPS was changed
On idle the engine jumps from 900-1200
Yeah I pulled out the throttle bodies. Did it with a friend so we were careful to plug all plugs properly. Just attached a picture
Thanks
Thanks Final Impact,
The TPS swap went smoothly. Also calibrated it with the diagnostic on the dashboard
It revs after 4500rpm
I'm bout to order a set of Iradium plugs (NGK CR9EIX), hope that's ok. I'll check plug caps too
Also I haven't checked the tank and injectors (which I was...
Hi,
So I finally got the time to change the TPS :cheer:
Thanks for all the help.
I've attached two pictures of the diagnostic reading when the throttle is open and closed. Closed = 15 and Open =100. I hope this is acceptable
The bike sounded better but I still have, the bike is still...
Hi All,
I noticed uneven idle on my TPS & a reduced mpg. I also followed a thread on how to diagnose the TPS
http://www.600riders.com/forum/fz6-technical/181-throttle-position-sensor-issues-you-experiencing-poor-idle-mileage-stalls-18.html?highlight=throttle+sensor+position
I came to a...
Explanation from top left:
1) Headlights down & back of the dashboard removed
2)Broken pin in the harness connector
3)Trying to bypass the pin by using an external wire to connect the wires originally connected to the broken pin
4)Dashboard back on holster
5)Bypass completed on both wires...
I'm having issues with uploading pictures from my computer. When I can figure it out I'll post the pictures
Would appreciate any directions on how to go about it