Hi guys I'm new to the group. I have just started my 08 fazer up first time for a couple of months. I let it run for a while and as stated in other posts, it started spewing the coolant out of a breather pipe. Need to look at the fanswitch, fan and water pump. Just wondering where do you guys get your parts from in the UK please? Cheers K
Looking at my FZ6 after a while. Need a road worthy certificate in Victoria Australia.
Change after market muffler to something big and fat. Thinking about lowering the footpegs for a bit more leg space.
About cam chain change, you've written there are 3 guides to change. But still confused about the 3th guide.
Can you send me a document about it, i can't find that part here :
I seen a post you made on a different thread about being able to get a manual for a bike I was going to see if by chance you didn't have anything on a 2009 FZ6R because I'm running into a intermittent code 19 and I currently have my side stand switch tied up without any pressure being put on the harness or any wires and still running into the issue as well as trying to figure out a charging issue
I seem to have a lag between throttle response and when chain gets power or tension. It felt like a loose chain slack but that is not the case. It makes for jerky shifting at lower power “ just cruising” speeds. Not sure how much slack in transmission is acceptable. I turn the wheel in gear on the stand and has quite a bit of rotation between forward and reverse rotation.
I bought a 2005 wrecked bike. Basically cosmetic damage. I needed a speedometer and headlight so I went with the 2007 S2 and have gotten the wire harness spliced and works. Will the speedometer bracket for the 2007 work on the 2005’s front forks to mount the headlight? I don’t believe they changed out the forks between years.
Hope you and the family are doing great! Saw the forum is locked and I'll assume your fixing or upgrading. Pretty quiet these days except a few signups that get pushed to the approval que.
Thank you for keep out forum alive!
Clif
Thanks for having me.
So my 2008 FZ6S has 70k on it and the engine runs tight the only issue I have is the clutch is a little noisy when released, quieter when the clutch is operated to select the gear.
Other than that the clutch works perfectly fine with no slip and full engagement.
I'm thinking it's time to start thinking about a new clutch kit, what is your advice please
Kind regards Robert
helping your hands on a long ride. I just installed the bar ends from H.V.M.P. on my 2008 FZ6S1. I believe these will cut down vibration and they look nice as well.